Welder Doghouse Enclosure - Vanguard CPW 125-4-S Series Operation And Maintenance Manual

037-11-35-025A 037-11-35-015A

Welder Doghouse Enclosure

Figure 43: Welder Doghouse Enclosure, door latched open, door latched closed
The Welder Doghouse Enclosure houses up to four welding power units. The welder doghouse enclosure's door folds up
and slides back into the top of the doghouse enclosure. The doghouse enclosure's door latches in place in either the open or
the closed position. The welding power units can be operated with the door of the welder doghouse enclosure in either the
open or closed position; ensure the door is secured in either the open or closed position when working.
037-11-35-025A
037-05-05-006A
Figure 44: Welder Power Units on extendable trays with latches
The welding power units are secured to extendable trays in the welder doghouse enclosure. The trays latch in place in the
retracted position. Unlatch the trays and slide the trays completely out to service the welder power units. Ensure the trays are
fully retracted and securely latched whenever the equipment is in use.
NOTE: Do not move or operate the weld-deck with the welder doghouse enclosure's trays in the extended position.
58
037-08OP-002D-01 S/N CB50600021 – UP (Weld-deck)