Fire Extinguisher Location; Electrical Cables And Wire-Harnesses - Vanguard CPW 125-4-S Series Operation And Maintenance Manual

If you find that you are involved in a machine fire, your safety and that of others on site is the top priority. The following
actions should only be performed if the actions do not present a danger or risk to you and any nearby people. At all times
you should assess the risk of personal injury and move away to a safe distance as soon as you feel unsafe.
Move the machine away from nearby combustible material such as fuel/oil stations, structures, trash, mulch and timber.
Lower any implements and turn off the engine as soon as possible. If you leave the engine running, the engine will continue
to feed a fire. The fire will be fed from any damaged hoses that are attached to the engine or pumps.
If possible, turn the battery disconnect switch to the OFF position. Disconnecting the battery will remove the ignition source
in the event of an electrical short. Disconnecting the battery will eliminate a second ignition source if electrical wiring is
damaged by the fire, resulting in a short circuit.
Notify emergency personnel of the fire and your location.
Use the on-board fire extinguisher, per the instructions on the fire extinguisher's instruction-plate, use the following
procedure:
1. Pull the pin.
2. Aim the extinguisher or nozzle at the base of the fire.
3. Squeeze the handle and release the extinguishing agent.
4. Sweep the extinguisher from side to side across the base of the fire until the fire is out.
Remember, if you are unable to do anything else, shut off the machine before exiting. By shutting off the machine, fuels will
not continue to be pumped into the fire. Use the emergency Stop button on the welder package to shut off the machine.
If the fire grows out of control, be aware of the following risks:
•
Tires on wheeled machines pose a risk of explosion as tires burn. Hot shrapnel and debris can be thrown great
distances in an explosion.
•
Tanks, accumulators, hoses, and fittings can rupture in a fire, spraying fuels and shrapnel over a large area.
•
Remember that nearly all of the fluids on the machine are flammable, including coolant and oils. Additionally,
plastics, rubbers, fabrics, and resins in fiberglass panels are also flammable.

Fire Extinguisher Location

Make sure that a fire extinguisher is available. Be familiar with the operation of the fire extinguisher. Inspect the fire
extinguisher and service the fire extinguisher. Obey the recommendations on the instruction plate.
Mount the fire extinguisher in the accepted location per local regulations.

Electrical cables and wire-harnesses

Do not bend electrical cables or wire-harnesses to a tighter radius than already installed. Do not strike electrical cables or
wire-harnesses. Do not kink electrical cables or wire-harnesses. Do not install kinked electrical cables or wire-harnesses. Do
not install damaged electrical cables or wire-harnesses.
Note: Only qualified personnel should work on electrical equipment, including electrical cables or wire-harnesses. Follow
established safety procedures when working on electrical equipment, including locking out operator controls as described in
the "General Hazard Information" section above.
Replace electrical cables or wire-harnesses with the same electrical rating, properties, and specifications as the original.
Contact your dealer or Vanguard for replacement parts.
Replace electrical cables or wire-harnesses if any of the following conditions are present:
•
The outer covering is chafed or cut.
•
The insulation is chafed, cut, or damaged in any way.
•
Signs of burning or arcing through the outer covering/insulation are present.
•
The electrical cable or wire-harness has been crushed by a heavy object.
Make sure that all clamps and guards are installed correctly. During operation, this will help prevent vibration and rubbing
against other parts.
037-08OP-003B
S/N 037201400021 – UP (T8 Slewing Canopy)
S/N 037200370021 – UP (D6N LGP Slewing Canopy)
14