T12 Auto Tie-In Crane Configure For Transport - Vanguard CPW 125-4-S Series Operation And Maintenance Manual

Machine Parking
Refer to the carrier's Operation and Maintenance Manual for specific machine parking instructions.
Transportation Information
Do not transport the machine with the Auto Tie-in Crane unsecured. Do not transport the machine with the Shack Deck
unsecured. Do not transport the machine with the Auto Tie-in Crane facing forwards.
Note: The total combined weights and Dimensions of the Auto Tie-in Crane, the Carrier Vehicle, and any additional
attachments must be considered when transporting the machine.
Note: The Auto Tie-in Crane should also be configured for transport whenever the carrier vehicle is being driven from one
location to another or whenever the carrier vehicle travels at a speed greater than normal "working" speed. For example,
when being driven from one work area to another, without any welding work being carried out between nearby pipe joints,
or when traveling from one welding set-up site to another.
Transport the machine with the Auto Tie-in Crane facing rearwards, never transport with the Auto Tie-in Crane facing
forwards.
Obey all jurisdictional transportation laws that apply. Refer to the Equipment Information Section (Auto Tie-in Crane) of
this manual for weight and dimension considerations of the Auto Tie-in Crane.

T12 Auto Tie-in Crane configure for transport

Figure 15: T12 Auto Tie-in Crane configured for transport.
037-08OP-004B
ATTACH HOOK
TO BOOM CLASP
037202650021 – UP (Auto Tie-in Crane)
CENTRE BOOM
AND BOOM REST
CENTRE BOOM
POSITION ON
BOOM REST
33