Lubrication Instruction - Vanguard CPW 125-4-S Series Operation And Maintenance Manual

Lubrication Instruction

Provisions about handling the respective lubricants must be observed.
While rotating the slewing drive, inject grease into all the cleaned grease nipples consecutively until a continuous
collar of fresh grease forms at least on one sealing lip.
Roller bearing lubricate point
Worm gear lubricate point
Roller bearing lubricate point
Figure 4.3 lubricate point
•
The roller bearings and worm gear are open to the same cavity, but it's suggested to fill them using the
separate grease points to be sure each is hit directly. The ball bearing is enclosed separately.
•
While rotating the slewing drive, inject grease into all the cleaned grease nipples consecutively as
follows:
•
Roller Bearings - 40 cc of grease
•
Worm Gear - 80 cc of grease
•
Ball Bearings -100 cc of grease
Ball bearings lubricate point
Ball bearings lubricate point
20 | S o l a r S l e w D r i v e M a n u a l