Battery Disconnect Switch - Vanguard CPW 125-4-S Series Operation And Maintenance Manual

Face the machine whenever getting on, off, or moving around the machine. Maintain three-point contact with the
steps/walkways and with the handholds.
Note: Three-point contact can be two feet and one hand. Three-point contact can also be one foot and two hands.
Do not a moving machine. Do not dismount a moving machine. Never jump off the machine. Do not try to mount or
dismount the machine while carrying tools or supplies. Use a hand line to pull equipment onto the platform. Do not use any
controls as handholds when entering or exiting the operator compartment.
Ground personnel must be kept clear at all times and only approach the machine when signaled to do so by the operator.

Battery Disconnect Switch

The battery disconnect switch is in the genset enclosure behind the main door on the right (fuel pump) side of the weld-deck.
Figure 22: Battery Disconnect Switch
I
ON — Insert the battery disconnect switch key, and turn the battery disconnect switch key clockwise in order to activate
the electrical system. The switch must be ON before you start the engine.
O
OFF — Turn the battery disconnect switch key counter clockwise in order to shut off the entire electrical system.
NOTE: Ensure the Genset Stop/Run/Start Switch is off for at least 30 seconds before turning the battery disconnect switch to
OFF to allow proper engine control module (ECM) shut down.
The battery disconnect switch and the genset Stop/Run/Start Switch serve different functions. When the battery disconnect
switch is turned off, the entire electrical system is disabled. When only the engine start switch is turned off, the battery
remains connected to the electrical system.
037-08OP-002D-01
037-11-50-025A
S/N CB50600021 – UP (Weld-deck)
037-09-63-009A
037-05-50-162A
40