Restrictions To Application And Configuration; Identification Information; Plate Locations And Film Locations; Ce Mark - Vanguard CPW 125-4-S Series Operation And Maintenance Manual

Restrictions to Application and Configuration

To obtain the proper lubrication, a maximum slope should not exceed a grade of 119 percent or 50 degrees up and down
angularity, and should not exceed 93 percent or 43 degrees side-to-side angularity. Do not exceed these limits. Do not
exceed the angularity or slope grade limits of the carrier vehicle.
Do not use this machine in explosive environments.

Identification Information

Plate Locations and Film Locations

The attachment/component information plate is attached to the component to identify the model name/number and the serial
number. It is not a Product Information Number (PIN). The attachment/component information plate is located under the left
catwalk at the front of the machine per the illustration below. For quick reference, record this information in the spaces that
are provided below

CE Mark

This information is positioned on the attachment/component information plate located under the left catwalk at the front of
the machine. For machines that are compliant to "2006/42/EC", the serial number (S/N), Model name/number (M/N), and
Manufacture year information is stamped onto the "CE" plate. For quick reference, record this information in the spaces
provided below:
35
037-08OP-002D-01 S/N CB50600021 – UP (Weld-deck)