Overload (6) - Vanguard CPW 125-4-S Series Operation And Maintenance Manual

Weld-deck welding package

Table of Contents

Overload (6)

Overload hazard! Boom overload hazard is present when load is being supported by the Auto Tie-in Crane with the boom

below horizontal. Do not lift or support a load with the boom below horizontal. Attempting a lift in this situation could

cause severe injury or death.

Safety message (6) is located on the left hand and right hand sides of the Auto Tie-in Crane Base.

Figure 6: Overload (6)

For additional crane safety films see Appendix 1.

For additional carrier safety films see the carrier OMM.

For T12 carrier tie-in crane specific films see Appendix 2.

037202650021 – UP (Auto Tie-in Crane)

037-08OP-004B

Table of Contents