Operation Section
Mounting and Dismounting
Warning! Crushing Hazard not attempt to mount or dismount the machine between the machine and any object that may
move.
Figure 20: Walkway retaining latches.
Extend all walkways before mounting the machine. The walkways are latched together for transport; unbolt the retaining
latches from the rear walkway, and bolt in the stowing position on each of the side walkways.
Figure 21: Typical welding package access; Walkways extended.
Mount the machine only at locations that have steps and/or handholds. Dismount the machine only at locations that have
steps and/or handholds. Before getting on the machine, clean the steps and handholds. Inspect the steps, handholds, and
walkways. Make all necessary repairs.
037-08OP-002D-01
RETAINING
LATCH
037-05-14-001A
RETAINING LATCH
(BOTH SIDES)
037-05-14-004A
037-05-05-109A
S/N CB50600021 – UP (Weld-deck)
RETAINING
LATCH
STOW LATCH WHEN
EXTENDING WALKWAYS
037-40-63-115A
037-05-14-005A
037-05-05-110A
39