No Clearance (3); Electrical Power Lines (4) - Vanguard CPW 125-4-S Series Operation And Maintenance Manual

No Clearance (3)

Crushing Hazard! Stay back a safe distance. No clearance for a person in this area when the Slewing Canopy turns.
Severe injury or death from crushing could occur.
Safety message (3) is located on the base of the Slewing Canopy Mast, above the lift cylinder attachment point. On the
Panther T8 tracked vehicle, Safety message (3) is located on the exterior left and right hand sides of the carrier vehicle near
the Slewing Canopy vehicle attachment supports. For D6M/N tractors, Safety message (3) is located on the front of the
Slewing Canopy Base.
Figure 3: No clearance (3)

Electrical Power Lines (4)

Electrocution Hazard! Keep the machine and attachments a safe distance from electrical power. Stay clear 3 M (10 ft)
plus twice the line insulator length. Read and understand the instructions and warnings in the Operation and
Maintenance Manual. Failure to follow the instructions and warnings will cause serious injury or death.
Safety message (4) is located on both sides of the base of the Slewing Canopy Mast
Figure 4: Electrical power lines (4)
037-08OP-003B
S/N 037201400021 – UP (T8 Slewing Canopy)
S/N 037200370021 – UP (D6N LGP Slewing Canopy)
8