Operation Section; Before Operation; Mounting And Dismounting; Daily Inspection - Vanguard CPW 125-4-S Series Operation And Maintenance Manual

Operation Section

Before Operation

Mounting and Dismounting

Figure 12: Mounting and dismounting machine
Refer to the carrier vehicle's Operation and Maintenance Manual for specific instructions and machine access way
information.
Refer to Vanguard Equipment's CPW-125-4 or CPW-125-4-S2 Weld-deck Operation and Maintenance Manuals for specific
instructions and machine access way information for Vanguard Equipment's weld-decks.

Daily Inspection

For maximum service life of the machine, perform a daily walk-around inspection.
Note: Watch closely for leaks. If leaking is observed, find the source of the leak and correct the leak. If leaking is suspected
or leaking is observed, check the fluid levels more frequently.
Inspect the machine for the following items:
•
Inspect the hydraulic system for leaks. Repair any hydraulic system leaks. Inspect the hoses, the seals, and the
flanges.
•
Inspect covers and the guards for damage, for loose bolts, and for missing bolts.
•
Inspect mirrors and make sure they are in good condition and replace if broken.
Note: Refer to the carrier vehicle's operation manual for detailed information on the specific daily inspection of the carrier
unit.
Accumulated grease and oil on a machine is a fire hazard.
Remove debris with steam cleaning or high-pressure water, at the specified interval in the Maintenance Interval Schedule or
each time any significant quantity of oil is spilled on the machine.
037-08OP-004B
Notice
037202650021 – UP (Auto Tie-in Crane)
28