5.3 Remote Control Layout - Vanguard CPW 125-4-S Series Operation And Maintenance Manual

5.3 REMOTE CONTROL LAYOUT

8
1. Emergency Stop Button – Push to activate. Pull to release. When activated the Emergency Stop Button stops
all outputs from the receiver.
2. Display Screen – LCD screen that displays many crane operating parameters. See Figure 4.
3. On/Off/Link Switch – Turns the Remote control on and off. Press and release the switch up to link the remote
control to the truck. "Link" the remote control to the truck every time it is turned on. Press and Hold the switch up
to access the Speed and Mode selection screen.
4. High Idle/Aux Switch – Press the toggle down to activate the High Idle on the vehicle. Aux activates an optional
feature.
5. Horn Button – Activates the Horn on the vehicle.
6. Right Joystick – Press the Joystick Up to raise the hook. Press the Joystick Down to lower the hook. Press the
Joystick Right to extend the boom and Left to retract the boom.
7. Left Joystick – Press the Joystick Up to raise the boom. Press the Joystick Down to lower the boom. Press the
Joystick Right to rotate the boom Clockwise. Press the Joystick Left to rotate the boom Counterclockwise.
8. Start/Stop Switch – Press the switch up to start the engine of the vehicle. Press the switch down to turn off the
engine of the vehicle.
1
Figure 4. Nexstar III Remote Control
7
2
18
3
4
5
6