Machine Parking; Genset Engine Stopping; Sound Level Information; Sound Level Information For Machines In European Union Countries And In Countries That Adopt The "Eu Directives - Vanguard CPW 125-4-S Series Operation And Maintenance Manual

Report any needed repairs that were noted during operation.
Connect trailing equipment to a drawbar or to a hitch on the carrier-vehicle only. DO NOT connect trailing equipment to the
weld-deck structure.

Machine Parking

Refer to the carrier's Operation and Maintenance Manual for specific machine parking instructions.

Genset Engine Stopping

Do not stop the genset-engine immediately after the machine has been operated under electrical-load. This can cause
overheating and accelerated wear of engine components.
After the electrical-load has been removed, allow the genset-engine to run at idle for 3 to 5 minutes before shutdown. This
allows hot areas of the engine to cool gradually.

Sound Level Information

Hearing protection is prescribed for an operator of the Weld-deck Welding Package CPW 125-4-S2.
Sound Level Information for Machines in European Union Countries and in Countries that
Adopt the "EU Directives"
Per the requirements under Noise in the Environment Directive 2000/14/EC, 2005/88/EC, Reg. 219/2009: The Weld-deck
Welding Package CPW 125-4-S2 is outside Article 12 and Article 13 definitions, but, as it is intended to be used outdoors in
conjunction with other equipment that must bear LWA marking, maximum guaranteed sound power level has been
calculated and the equipment is marked114dB (A).
Hearing protection is prescribed for an operator of the Weld-deck Welding Package CPW 125-4-S2.

Vibration

When the machine is operated according to the intended use, the vibration data for the carrier-vehicle is unaffected by
attachment of the CPW Package.

Guards (Operator Protection)

There are different types of guards that are used to protect the operator. The machine and the machine application determine
the type of guard that should be used.
A daily inspection of the guards is required in order to check for structures that are bent, cracked or loose. Never operate a
machine with a damaged structure.
The operator becomes exposed to a hazardous situation if the machine is used improperly or if poor operating techniques are
used. This situation can occur even though a machine is equipped with an appropriate protective guard. Follow the
established operating procedures that are recommended for your machine.
037-08OP-002D-01 S/N CB50600021 – UP (Weld-deck)
31