Not A Lifting Device (2) - Vanguard CPW 125-4-S Series Operation And Maintenance Manual

Not a Lifting Device (2)

Dropping load hazard! Do not attempt to use the Slewing Canopy as a lifting device, crane, or as a lifting jib or boom
to raise or support any type of load other than the intended use. Only use the Slewing Canopy to support and carry
the welding cables and lightweight accessories used for Manual Metal Arc Welding operations, such as hand grinders
or other similar tools. Do not overload the Slewing Canopy, serious equipment damage, personnel injury, or even
death could result. Refer to the Load Capacity section of this manual.
Safety message (2) is located on the front of the left Slewing Canopy storage box (if equipped with a storage box), or on the
left and right sides of the Slewing Canopy Base if not equipped with storage boxes, and on the outer end of the Slewing
Canopy on both sides of the tube. Safety message (2) is located inside the Operator Station of the carrier vehicle: on the right
front cab-pillar in Panther T8 tracked vehicle, on the left font pillar in the cab (EROPS) of a D6M/N, or besides the right
armrest in the Canopy (ORPS) D6M/N.
Figure 2: Not a lifting device (2)
037-08OP-003B
S/N 037201400021 – UP (T8 Slewing Canopy)
S/N 037200370021 – UP (D6N LGP Slewing Canopy)
7