Operator Controls - Vanguard CPW 125-4-S Series Operation And Maintenance Manual

Operator Controls

The hydraulic functions of the Slewing Canopy Attachment are controlled by the carrier vehicle's implement controls. Refer
to the specific carrier vehicle's Operation and Maintenance manual for information regarding the type and location of the
implement controls.
The implement controls may consist of either two separate levers, or there may be a single multifunction control. For two
lever controls, there will be one lever to control the raise and lower functions and another for multifunction controls, such as
the blade control on a dozer, one control axis will operate the raise and lower functions, and another axis will control the
slewing functions.
The relevant carrier vehicle's implement controls should be relabeled with the correct hydraulic function symbols for the
Slewing Canopy Attachment as shown in this section. Contact your dealer to obtain replacement symbols and installation
instructions if any or all of the symbols are not present.
Figure 8: Typical implement control location - Panther T8 tracked vehicle
Figure 9: Typical implement control location - D6N LGP tractor
037-08OP-003B
037-T8-05-006A
037-D6N-05-001B
S/N 037201400021 – UP (T8 Slewing Canopy)
S/N 037200370021 – UP (D6N LGP Slewing Canopy)
037-T8-63-003A
037-T8-63-003A
037-T8-63-001A
037-09-043
24