Genset Engine Gauges And Indicators - Vanguard CPW 125-4-S Series Operation And Maintenance Manual

Genset Engine Gauges and Indicators

Figure 28: Genset Engine Gauges and Indicators
Service Hour Meter (1) — This gauge indicates the total operating hours of the genset. The service hour meter
should be used to determine service hour maintenance intervals.
Genset Engine Coolant (1) — This gauge indicates the temperature of the genset engine coolant.
Note: The genset engine will automatically shutdown if the Engine Control Module (ECM) detects that the coolant
temperature exceeds107 ºC (225 ºF).
Genset Engine Oil Pressure (3) — This gauge indicates the oil pressure of the genset engine.
Note: The genset engine will automatically shutdown if the Engine Control Module (ECM) detects low oil
pressure; 69 kPa (10 psi) @ low idle, 207 kPa (30 psi) @ rated speed.
Battery Charge Meter (4) — This gauge indicates the charge state
genset is running, or by pressing the WHITE control panel illumination
037-08OP-002D-01
037-05-63-309A
6
S/N CB50600021 – UP (Weld-deck)
037-05-63-310C
5
037-05-63-310B
of the 24Volt-DC batteries whenever the
button when the genset is stopped.
1
2
3
4
5
44