Operator Controls; Auto Tie-In Crane Controls - Vanguard CPW 125-4-S Series Operation And Maintenance Manual

Operator Controls

The hydraulic functions of the Auto Tie-in Crane Attachment are controlled by a remote control.
2
1
3
4
5
8
6
7
Figure 13: Typical crane remote control layout
The speed of the Auto Tie-in Crane will be dependent on the engine RPM speed driving the hydraulic implement pump. The
faster the engine RPM, the faster the Auto Tie-in Crane operational speed.

Auto Tie-in Crane Controls

Note: Refer to the specific carrier vehicle's Operation and Maintenance manual for information regarding operation of the
implement controls when they are released.
1. Emergency Stop Button – Push to activate. Pull to release. When activated the Emergency Stop Button stops all outputs
from the receiver.
2. Display Screen – LCD screen that displays many crane operating parameters. See Figure 14.
3. On/Off/Link Switch – Turns the Remote control on and off. Press and release the switch up to link the remote control to
the truck. "Link" the remote control to the truck every time it is turned on. Press and Hold the switch up to access the Speed
and Mode selection screen.
4. High Idle/Aux Switch – Press the toggle down to activate the High Idle on the vehicle. Aux activates an optional feature.
5. Horn Button – Activates the Horn on the vehicle.
6. Right Joystick – Press the Joystick Up to raise the hook. Press the Joystick Down to lower the hook. Press the Joystick
Right to extend the boom and Left to retract the boom.
7. Left Joystick – Press the Joystick Up to raise the boom. Press the Joystick Down to lower the boom. Press the Joystick
Right to rotate the boom Clockwise. Press the Joystick Left to rotate the boom Counter clockwise.
8. Start/Stop Switch – Press the switch up to start the engine of the vehicle. Press the switch down to turn off the engine of
the vehicle
.
30
037202650021 – UP (Auto Tie-in Crane)
037-08OP-004B