Hyundai HX130LCR Manual page 591

Hide thumbs Also See for HX130LCR:

Table of Contents

Note that the plated surface of rod

assembly (1) is to be lifted. For this

reason, do not use a wire sling and

others that may damage it, but use a

strong cloth belt or a rope.

Place the removed rod assembly on a

wooden V-block that is set level.

Cover a V-block with soft rag.

Remove piston and cylinder head

Remove set screw (24) and lock nut

Since set screw (24) and piston nut (23)

is tightened to a high torque, use a

hydraulic and power wrench that utilizers

a hydraulic cylinder, to remove the lock

set screw (24) and piston nut (23).

Remove piston assembly (17), back up

ring (22), and O-ring (21).

Remove the cylinder head assembly

from rod assembly (3).

If it is too heavy to move, move it by

striking the flanged part of cylinder head

with a plastic hammer.

Pull it straight with cylinder head

assembly lifted with a crane.

Exercise care so as not to damage the

lip of pin bushing (4) and packing

(8,9,10,11,12) by the threads of rod

assembly (3).

Lift with a crane

Wooden block

Pull straight

Troubleshooting