Hyundai HX130LCR Manual page 271

J1939 Code
1110-31 Engine Protection System has Shutdown Engine
Engine Turbocharger 1 Boost Pressure : High -
1127-16
moderate severity (2)
Engine Turbocharger 1 Boost Pressure : Low -
1127-18
moderate severity (2)
Engine Turbocharger Wastegate Actuator 1 Position
1188-5
: Current Below Normal
Engine Turbocharger Wastegate Actuator 1 Position
1188-6
: Current Above Normal
Engine Exhaust Gas Pressure : Voltage Above
1209-3
Normal
Engine Exhaust Gas Pressure : Voltage Below
1209-4
Normal
Continuously Monitored Systems Support/Status ;
1221-2
Erratic, Intermittent, or Incorrect
Continuously Monitored Systems Support/Status ;
1221-14
Special Instruction
1239-0 Engine Fuel Leakage 1 : High - most severe (3)
1485-7 ECM Main Relay : Not Responding Properly
1485-14 ECM Main relay : Special Instruction
Engine Exhaust Gas Recirculation (EGR) Valve
2791-5
Control : Current Below Normal
Engine Exhaust Gas Recirculation (EGR) Valve
2791-6
Control : Current Above Normal
Engine Exhaust Gas Recirculation (EGR) Valve
2791-7
Control : Not Responding Properly
2797-6 Engine Injector Group 1 : Current Above Normal
2797-7 Engine Injector Group 1 : Not Responding Properly Injector Solenoid - Test
2798-6 Engine Injector Group 2 : Current Above Normal
2840-12 ECU Instance : Failure
2840-14 ECU Instance : Special Instruction
※ Some fault codes are not applied to this machine.
Description
5-44
Refer to Procedure
The engine protection system has
shutdown the engine. Troubleshoot all other
diagnostic codes in order to clear this code.
Intake Manifold Air Pressure Is High
Intake Manifold Air Pressure Is Low
Solenoid Valve - Test
Solenoid Valve - Test
Sensor Signal (Analog, Active) - Test
(Exhaust Gas Pres- sure Sensor)
Sensor Signal (Analog, Active) - Test
(Exhaust Gas Pres- sure Sensor)
ECM Memory - Test
Another diagnostic code has requested
engine speed limitation.
The warning lamp will flash. The engine
speed is limited to 1200 rpm.
Troubleshoot all other diagnostic codes. If
this code is the only active diagnostic code,
replace the ECM. Refer to Troubleshooting,
"ECM - Replace"
Fuel Rail Pressure Problem
Relay - Test (ECM Main Relay)
Relay - Test (ECM Main Relay)
Motorized Valve - Test
Motorized Valve - Test
Motorized Valve - Test
Injector Solenoid - Test
Injector Solenoid - Test
ECM Memory - Test
Relay - Test (ECM Main Relay)