Hyundai HX130LCR Manual page 481

Hide thumbs Also See for HX130LCR:

Table of Contents

Even though assembly is accomplished by

reversing disassembly steps, be careful of the

Repair the damaged part when disassemblying

and prepare parts for exchange in advance.

All parts should be cleaned with cleaner, dried

with compressed air.

Sliding surface, O-ring, bearing and oil seal

should be lubricated with clean hydraulic oil,

prior to final assembly.

Replacement of O-ring and oil seal with new

parts is generally recommended.

Use a torque wrench to make sure that

assembly fasteners are tightened to specified

When assembling bolt, spread loctite.

Put casing (1) on worktable.

Press oil seal (2) using oil seal jig, until it reach

Spread grease on external diameter of oil seal.

Mount cylinderical roller bearing (5, 6) on shaft

(3) using shrink fitting method.

Troubleshooting