Hyundai HX130LCR Manual page 300

(3) User mode switch
290F3CD89
(4) Travel speed switch
290F3CD91
(5) Auto idle/ buzzer stop switch
290F3CD90
(6) Escape/Camera switch
290F3CD92
(7) Work light switch
290F3CD93
This switch is used to memorize the current machine operating
①
status in the MCU and activate the memorized user mode.
·Memory : Push more than 2 seconds.
: Push within 2 seconds.
·Action
·Cancel : Push this switch once more within 2 seconds.
Refer to the page 5-76 for another set of user mode.
②
This switch is used to select the travel speed alternatively.
①
: Low speed
·
: High speed
·
Do not change the setting of the travel speed switch. Machine
※
stability may be adversely affected.
Personal injury can result from sudden changes in machine
stability.
This switch is used to activate or cancel the auto idle function.
①
·Pilot lamp ON : Auto idle function is activated.
·Pilot lamp OFF : Auto idle function is cancelled.
The buzzer sounds when the machine has a problem.
②
In this case, push this switch and buzzer stops, but the
warning lamp blinks until the problem is cleared.
This switch is used to return to the previous menu or parent
①
menu.
In the operation screen, pushing this switch will display the
②
view of the camera on the machine (if equipped).
Please refer to page 5-88 for the camera.
If the camera is not installed, this switch is used only ESC
③
function.
This switch is used to operate the work light.
①
The pilot lamp is turned ON when operating the switch.
②
5-72