Hyundai HX130LCR Manual page 607

Hide thumbs Also See for HX130LCR:

Table of Contents

Install dust seal (11), back up ring (10)

and rod seal (9) to body (1).

When installing dust seal (11) and rod

seal (9), take full care so as not to

damage the lip.

Pour grease into body (1), then push in

rod (12) by hand.

After take grease out of grease valve

mounting hole, let air out.

If air letting is not sufficient, it may be

difficult to adjust the tension of crawler.

Fit grease valve (13) to rod (12).

·Tightening torque : 13.0±0.5 kgf·m

Install spring (3) and bracket (4) to body

Apply pressure to spring (3) with a press

and tighten lock nut (5).

Apply sealant before assembling.

During the operation, pay attention

specially to prevent the press from

slipping out.

(94.0±3.6 lbf·ft)

Troubleshooting