Hyundai HX130LCR Manual page 270

J1939 Code
652-21 Engine Injector Cylinder #02 : Data Drifted Low
Engine Injector Cylinder #03 : Current Below
653-5
Normal
Engine Injector Cylinder #03 : Current Above
653-6
Normal
653-20 Engine Injector Cylinder #03 : Data Drifted High
653-21 Engine Injector Cylinder #03 : Data Drifted Low
Engine Injector Cylinder #04 : Current Below
654-5
Normal
Engine Injector Cylinder #04 : Current Above
654-6
Normal
654-20 Engine Injector Cylinder #04 : Data Drifted High
654-21 Engine Injector Cylinder #04 : Data Drifted Low
676-5 Engine Glow Plug Relay : Current Below Normal
676-6 Engine Glow Plug Relay : Current Above Normal
676-19 Engine Glow Plug Relay : Data Error
677-3 Engine Starter Motor Relay : Voltage Above Normal Relay - Test (Start Relay)
677-5 Engine Starter Motor Relay : Current Below Normal Relay - Test (Start Relay)
677-6 Engine Starter Motor Relay : Current Above Normal Relay - Test (Start Relay)
Engine Speed Sensor #2 : Abnormal Frequency,
723-8
Pulse Width, or Period
970-31 Engine Auxiliary Shutdown Switch
PTO Governor State : Erratic, Intermittent, or
976-2
Incorrect
Start Signal Indicator : Erratic, Intermittent, or
1041-2
Incorrect
Engine Fuel Injection Pump Fuel Control Valve :
1076-2
Erratic, Intermittent, or Incorrect
Engine Fuel Injection Pump Fuel Control Valve :
1076-5
Current Below Normal
Engine Fuel Injection Pump Fuel Control Valve :
1076-6
Current Above Normal
1081-5 Engine Wait to Start Lamp : Current Below Normal
1081-6 Engine Wait to Start Lamp : Current Above Normal
※ Some fault codes are not applied to this machine.
Description
5-43
Refer to Procedure
Injector Data Incorrect - Test
Injector Solenoid - Test
Injector Solenoid - Test
Injector Data Incorrect - Test
Injector Data Incorrect - Test
Injector Solenoid - Test
Injector Solenoid - Test
Injector Data Incorrect - Test
Injector Data Incorrect - Test
Glow Plug Starting Aid - Test
Glow Plug Starting Aid - Test
Glow Plug Starting Aid - Test
Speed/Timing - Test
This code indicates that the shutdown switch
for the engine has been activated.
The ECM will disable fuel injection until
the switch has been deactivated. No
troubleshooting is required.
Power Take-Off - Test
Relay - Test (Start Relay)
Solenoid Valve - Test
Solenoid Valve - Test
Solenoid Valve - Test
Indicator Lamp - Test
Indicator Lamp - Test