Hyundai HX130LCR Manual page 431

3. COMPLETING WORK
If the coolant has been drained, tighten the drain valve, and add water to the specified level. Run
1)
the engine to circulate the water through the system. Then check the water level again.
If the hydraulic equipment has been removed and installed again, add engine oil to the specified
2)
level. Run the engine to circulate the oil through the system. Then check the oil level again.
If the piping or hydraulic equipment, such as hydraulic cylinders, pumps, or motors, have been
3)
removed for repair, always bleed the air from the system after reassembling the parts.
Add the specified amount of grease (molybdenum disulphied grease) to the work equipment
4)
related parts.
8-3