Hyundai HX130LCR Manual page 543

Hide thumbs Also See for HX130LCR:

Table of Contents

After spreading grease sufficiently to the bottom

side of valve plate (24), assemble valve plate in

rear cover by matching its holes with pins.

Take care not to damage sliding surface.

Pay attention to the assembly direction.

Assemble O-ring (27) in rear cover.

Spread grease on O-ring.

Put rear cover upon casing, paying attention to

the location of pin and hole. And tighten bolt

(47), (48) and (49).

Tightening torque : 17.5±1.8 kgf · m

(127±13.0 lbf · ft)

Make sure valve plate stays in place.

Check bolt position.

Assemble main spool assembly (31), spring seat

(37) and spring (33) in rear cover.

Troubleshooting