Hyundai HX130LCR Manual page 487

Hide thumbs Also See for HX130LCR:

Table of Contents

Assemble O-ring (18) & cylinderical roller

bearing (6) in valve casing.

Use jig (press fit or cold shrink fit).

Apply grease on steel side of valve plate (20) to

prevent plate from sliding.

Assemble valve plate with the copper side facing

Pay attention to the assembly direction.

Take care not to damage sliding surface.

Assemble valve casing by matching its holes

and pins of casing and parking piston. And

tighten socket bolt (38) (4EA) using 12 mm

hexagon wrench.

Tightening torque : 17.5±1.7 kgf · m

(127±12.7 lbf · ft)

Make sure valve plate stays in place.

When tightening bolts, make sure mating

surfaces between casing and valve casing

maintain parallel to each other.

Assemble relief valve assembly (31) using

36 mm socket wrench in valve casing.

Spread grease on O-ring part of relief valve

Tightening torque : 18.0±1.8 kgf · m

(130±13.0 lbf · ft)

Troubleshooting