Table 54 Input Arguments Of The Inputsimulationpin Method - WAGO 765-1205/100-000 Product Manual

765-1205/100-000
3. Enter the Force ID, the Force Mask and the Force Data (the input arguments are
described below, including an example).
4. Click [Call].
ð If the method call was successful, the input data is transmitted to the controller.
ð If the method call was unsuccessful, then "−1" appears under Status.
Description of the Input Arguments
Input Arguments
Force ID
Force Mask
Product manual | Version: 2.0.0
8DIO FLD EC DC 24V 2.0A
Figure 36: InputSimulationPin4 Method
Table 54: Input Arguments of the InputSimulationPin Method
Description
Here the OPC UA client must use the Force ID that the
OPC UA client had received after the GetForcingID
method was called.
Ports for which simulation should be enabled. Bit mask
and port assignment:
Bit 0: port X01,
Bit 1: port X02,
Bit 2: port X03, ...
Bit value 0: Simulation disabled for this port.
Bit value 1: Simulation enabled for this port.
Example 1: A value of 4 enables simulation for port
X03.
Example 2: A value of 7 enables simulation for ports
X01, X02 and X03.
Commissioning
93