Setting Parameters; Parameterization; Wago Webserver I/O Field; Call Wago Webserver I/O Field - WAGO 765-1205/100-000 Product Manual

Commissioning

10.2.1.2 Setting Parameters

You can set the parameters for the module in the configuration software of the EtherCAT
master. The existing parameters contain the basic settings for the module, which you can
adapt to your application. Set the module and port parameters in the start-up parameters
in the configuration software of the EtherCAT
these parameters to the module when communication starts up.
You can find all the module parameters in

10.3 Parameterization

The following tools are described below:
8 WAGO Webserver I/O Field [} 58]
•
8 WAGO I/O Field app [} 76]
•
8 OPC UA Server [} 76]
•

10.3.1 WAGO Webserver I/O Field

10.3.1.1 Call WAGO Webserver I/O Field

This section describes how you can use the integrated software WAGO I/O Field Web-
server to get access to detailed information on the current operating state of the product
and make settings to affect the product's behavior.
ü Requirement: Opening the user interface of WAGO I/O Field Webserver requires that
product's IP address is configured and known.
• Proceed as follows:
Enter the following text in the address bar of your Web browser to address the prod-
uct:
http://<IP-address-according-to-configuration>
e.g., http://192.168.10.2.
ð The WAGO I/O Field Webserver Dashboard appears. You can now use the functions
described below.
58 Product manual | Version: 2.0.0
8DIO FLD EC DC 24V 2.0A
®
master. The EtherCAT
8 Module Parameters
[} 41].
765-1205/100-000
®
®
master sends