Operator's Presence System Checks - MacDon M150 Assembly Instructions Manual

V. OPERATOR'S PRESENCE SYSTEM
CHECKS
a. With the windrower engine running, place the
GSL in Neutral and turn the steering wheel until
it locks.
CAUTION
Check to be sure all bystanders have cleared
the area.
b. With everyone clear of the machine, engage
header drive switch.
1. After header drives are running, stand up
out of the seat. In approximately 5 seconds
the header should shut off. If not, the
operator presence
adjustment.
Manual.
To restart the header, move the header
engage switch to "OFF" position and
back to the "ON" position again.
c. With the engine running, position the GSL in
Neutral and in N-DETENT;
1. Swivel the operator's station but do not lock
into position.
2. Move GSL out of N-DETENT. The engine
should shut down and the lower display will
flash "LOCK SEAT BASE ---> CENTER
STEERING
NEUTRAL".
3. Swivel and lock the operator's station and
the display should return to normal.
4. If the engine does not shut down, the seat
position switches require adjustment. Refer
to Technical Service Manual.
d. With the windrower moving at less than 3 mph;
1. Stand up out of the seat.
2. The CDM will flash "NO OPERATOR" on the
upper line, and "ENGINE SHUTDOWN
5...4...3...2...1...0"
accompanied by a steady tone. At "0", the
engine shuts down.
3. If the engine does not shut down, the
operator presence
adjustment.
Manual.
e. With the windrower moving at more than 3 mph;
1. Stand up out of the seat.
2. The CDM beeps once and displays "NO
OPERATOR" on the lower line.
Form # 169018
PRE-DELIVERY CHECKS
system requires
Refer to Technical Service
NOTE
WHEEL ---> NOT
on the lower
system requires
Refer to Technical Service
3. If not, the operator presence system
requires adjustment.
Service Manual.
IN
line
41
Refer to Technical
Model Year - 2009