Operator's Presence System Checks; Exterior Lights - MacDon M100 Unloading And Assembly Instructions

VII. OPERATOR'S PRESENCE SYSTEM
CHECKS
a. With the windrower engine running, place the
GSL in Neutral and turn the steering wheel until
it locks.
CAUTION
Check to be sure all bystanders have cleared
the area.
b. With everyone clear of the machine, engage
header drive switch.
1. After header drives are running, stand up
out of the seat. In approximately 5 seconds
the header should shut off. If not, the
operator presence
adjustment, refer to the M100 Operator's
Manual for adjustment procedures.
To restart the header, move the
header engage
position and back to the "ON" position
again.
c. With the windrower moving at less than 3 mph;
1. Stand up out of the seat.
2. The CDM will flash "NO OPERATOR" on the
upper line, and "ENGINE SHUTDOWN
5...4...3...2...1...0"
accompanied by a steady tone. At "0", the
engine shuts down.
3. If the engine does not shut down, the
operator presence
adjustment, refer to the M100 Operator's
Manual for adjustment procedures.
d. With the windrower moving at more than 3 mph;
1. Stand up out of the seat.
2. The CDM beeps once and displays "NO
OPERATOR" on the lower line.
3. If not, the operator presence system
requires adjustment, refer to the M100
Operator's Manual
procedures.
Form # 169390
PRE-DELIVERY CHECKS
system requires
NOTE
switch to "OFF"
on the lower
system requires
for adjustment
VIII. EXTERIOR LIGHTS
FIELD LIGHTS
line
a. Switch on field lights and check that all lights as
shown are functioning.
b. Turn off lights.
41
FRONT
FIELD LIGHTS
SWATH LIGHTS
REAR
(continued next page)
Model Year - 2010