Operational Checks; Engine Warning Lights; Start Engine - MacDon M150 Assembly Instructions Manual

J. OPERATIONAL CHECKS
I. ENGINE WARNING LIGHTS
a. Turn ignition key to RUN position.
b. Single loud tone sounds, and engine warning
lights illuminate.
II. START ENGINE
a. Check fuel level and if required add sufficient
fuel for a 15 minute run.
A
b. Operator's station lock (A) must be engaged at
cab forward or engine forward position.
c. Move GSL (B) into N-DETENT.
F
D
E
OFF RUN
d. Turn steering wheel until it locks.
e. Push header drive switch (C) to off.
f. Normal Start - engine temperature above 60°F
(16°C):
1. Set throttle (D) to start position (E) – fully
back.
2. Turn ignition key (F) to RUN position.
3. Single loud tone sounds, engine warning
lights illuminate and CDM displays HEADER
DISENGAGED or DISENGAGE HEADER
and IN PARK.
Form # 169018
PRE-DELIVERY CHECKS
B
B
C
START
CAUTION
Check to be sure all bystanders have cleared
the area.
4. Turn ignition key to START position until
engine starts and then release key. Tone
ceases and warning lights go out.
displays programmed header data for 5
seconds if attached and then returns to
previous display.
Do not operate starter for longer than
15 seconds at a time. If engine does
not start, wait at least two minutes
before trying again. After the third 15
second crank attempt, allow starter to
cool for 10 minutes before further
cranking attempts. If engine still does
not start, refer to the following table:
PROBLEM
Controls not in neutral.
Neutral interlock
misadjusted.
No fuel to engine.
Old fuel in tank.
Water, dirt or air in fuel
system.
Improper type of fuel.
Crankcase oil too
heavy.
Low battery output.
Poor battery
connection.
Faulty starter.
Wiring shorted, circuit
breaker open.
Faulty injectors.
g. Cold Start - engine temperature below 40°F
(5°C).
M200 – CAT ENGINE
1. Set throttle (D) to start position (E) – fully
back (low idle).
2. Turn key to RUN.
3. Single loud tone sounds, engine warning
lights illuminate and CDM displays HEADER
DISENGAGED or DISENGAGE HEADER
and IN PARK.
39
IMPORTANT
SOLUTION
Move GSL to neutral.
Move steering wheel to locked
position.
Disengage header clutch.
Contact MacDon dealer.
Fill empty fuel tank, replace
clogged filter.
Drain tank, refill with fresh fuel.
Drain, flush, fill and prime
system.
Use proper fuel for operating
conditions.
Use recommended oil.
Have battery tested. Check
battery electrolyte level.
Clean and tighten loose
connections.
Contact MacDon dealer.
Check continuity of wiring and
breaker (manual reset).
Contact MacDon dealer.
(continued next page)
Model Year - 2009
CDM