Tektronix DG2040 User Manual page 80

Tutorial 5: Controlling
Pattern Edges
DG2040 Data Generator
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Menu button Bottom button
The file called SEQ1.PDA is created. If a file of the same name already
exists, a message asking if that file should be overwritten will be displayed.
Press OK once more if that message is displayed.
The instrument has a function to move the specified pattern edges within the
range of "100 ps relative to the original position. You can specify the pattern
edge(s) in the DATA0 by using the DATA1 pattern.
In the following procedures, you create the pattern in the DATA0 as shown in
Figure 2-34, in which the highlighted edges are controlled and moved.
DATA1
DATA0
10 points
Figure 2 34: Pattern and edges to be controlled in the DATA0
To specify those edges to be controlled, you also create the pattern in the DATA1
as shown in Figure 2-34.
1. Follow the steps below to create a pattern in the DATA0.
a. Reset to factory setting.
Menu button Bottom button
UTILITY System
pop up menu Side button
Clear String
SEQ1 OK
10 points
pop up menu Side button
Reset to Facto
ry
OK
Operating Basics
Front panel
button
Front panel
button
2 49