Table of Contents
Advertisement
DG2040 Data Generator
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
H Function generator
Output channel
. . .
Waveform
. . . . . . .
Frequency
. . . . . . .
Amplitude
. . . . . . .
Offset
. . . . . . . . . .
Procedure. Follow the steps below to verify that the edge control mode operation
is functioning correctly.
1. Load the TP7EDGE.PDA test pattern file from the performance check disk.
2. Press the START/STOP button on the front panel. The LED, corresponding
to the button, should be on.
3. Adjust the Main Pos control on the sampling oscilloscope front panel. Verify
that jitter appears only on the rising edge portion on the CH0 output signal
after the CH1 output signal rises. See figure B-16.
4. Press the START/STOP button on the front panel to stop output. The LED,
corresponding to the button, is turned off.
CH1
(CH0 OUT)
CH2
(CH1 OUT)
Figure B 16: Edge control mode
Appendix B: Performance Verification
CH2
Square wave
10 MHz
2 V
0 mV
B 31
Advertisement
Table of Contents
