Table of Contents
Advertisement
Export
DG2040 Data Generator
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
1. Insert the 3.5 inch floppy disk with the first 128 K words into the drive.
2. Select File ! Import Data and select a file to be imported.
3. Press the OK button. The Import Configuration pop-up menu appears. This
menu allows you to configure how the data will be imported. In this
example, only the Dest Start point will be modified.
4. Set the Dest Start point to zero for the first 3.5 inch floppy disk.
5. Set the Dest Start point to 65536 for the second 3.5 inch floppy disk.
6. Set the Dest Start point to 131072 for the third 3.5 inch floppy disk.
7. Repeat the steps above changing the Dest Start point until the data from the
last 3.5 inch floppy disk is read.
Once the data words have been imported, parameters including clock rate, output
levels, and interchange timing need to be set, since the CSV format does not
transfer this information.
The Export function writes pattern data to mass memory (3.5 inch floppy disk).
Data is written either as CSV data or as Tektronix AWG2000-Series waveform
data. The write method is specified by setting a parameter in a pop-up menu.
NOTE. Icon data and hardware setup data are not saved in the output AWG2000
Series waveform data. When this data is read in to an AWG2000 Series
instrument, default setup data will be added. PCs and some other systems may
not be able to read this data directly.
Operation.
Do the following to write pattern data to mass memory.
Bottom button
Pop up menu
Insert a write enabled 3.5 inch floppy disk in the floppy disk drive.
File
Select the format of the data to be written
(either CSV data or AWG2000s Waveform
data).
Enter the file name for the data to be written.
Change the parameters as required.
Reference
Side button
Export Data
OK
OK
OK
3 15
Advertisement
Table of Contents
