Table of Contents
Advertisement
Mirror Horizontal
Magnify
Numeric Input
DG2040 Data Generator
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
This Action menu function is used for the timing display format and the cursor
becomes the area cursor. The area specified as the editing area is reordered in the
point direction in a mirror-image manner. In display formats other than timing
display (such as table and binary), the reordering is performed in the group/bit
direction.
Before
Execution
After
Execution
Figure 3 33: Mirror horizontal
In this Action menu function, the cursor becomes the area cursor, and the data in
the area specified as the editing area is magnified in the direction of the time
axis. This function has one parameter, the magnification factor (Mag Factor).
This can be set to any integer from 2 to 100.
For example, if the Mag Factor is 2, then magnifying a data range with the data
0101 would give the data 00110011. This editing operation repeats each data
item the number of times specified by the Mag Factor parameter.
The data following the edit area is moved to the rear from the editing area by the
amount of the data increased due to the magnification. The data in the tail that
exceeds the memory size is lost.
Before
Execution
After
Execution
Editing Area
Figure 3 34: Magnify
In this Action menu function, the cursor switches to the point cursor, and the
input position is indicated on the display. Data can then be changed by input of
numeric values. As data is input, existing data at the input position is overwrit-
ten.
After selecting Numeric input from the Action Menu, step is set using the
Points/Step pop-up window. A "step" is the number of points that are set for
each number that is input.
Editing Area
Reference
3 39
Advertisement
Table of Contents
