Tektronix DG2040 User Manual page 65

Operating Basics
Tutorial 3: Signal Output
2 34
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
6. Save the edited data on the 3.5 inch floppy disk.
a. Insert a formatted 3.5 inch floppy disk in the drive.
b. Name the new file COUNT2.
Menu Button Bottom Button
File
The data in this procedure will be saved in the file COUNT2.PDA.
Tutorial 3 sets all the settings required for signal output and actually outputs the
signals.
1. Set the sampling clock frequency to 500 MHz.
Menu button Bottom button
Clock
2. Set the signal generation mode to continuous mode.
Menu button Bottom button
Run Mode
3. Set the channel CH0 to CH1 output levels to 1 V for the high level and –1 V
for the low level.
Pop up Menu Side Button
Save Data &
Setup
Clear String
COUNT2 OK
Pop up menu Side button
Reference
(Select Int.)
Int FREQ
Pop up menu Side button
Repeat
DG2040 Data Generator
Front Panel
Button
Front panel
button
500
MHz
Front panel
button