Tektronix DG2040 User Manual page 112

Block 1
Move to Previous Block Move to Block Start
Figure 3 18: Block cursor movement
Add Block Delimiter Here
DG2040 Data Generator
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Current Cursor Position
Move to Block End
Block 2 Block 3
Move to Next Block
Operation.
Do the following to move the cursor relative to the current block.
Bottom button
Block
The Add block delimiter here item in the pop-up menu sets a block delimiter at
the current cursor position. The delimiter point becomes the starting point of the
new block. The block delimiter is marked on the point scale.
NOTE. A block delimiter cannot be set at a point that is not at least 360 points
away from both the start and the end of the block in which the delimiter is being
set.
Before
Division
360 Points or Over
After
Block 1
Division
Figure 3 19: Dividing a block
Move to Block (Any)
Pop up menu
Select from the following items:
Move to block start
Move to block end
Move to next block
Move to previous block
Move to block (any)
Select the block to move to.
(Move to block (any) only)
Current Cursor Position
Block 1
360 Points or Over
Block 2
Set a Block Delimiter
Reference
Block n
Side button
OK
OK
Block 3
Block 3
3 29