Tektronix DG2040 User Manual page 159

Reference
Line No.
0
Sequence Output BK0 BK1
Trigger Input
Event Input
Figure 3 64: Enhanced Mode sequence output
Update
3 76
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Repeat
Line No. Block
Count
0 BK0 1
1 BK1 Infinite
2 BK2 2
3 BK3 2
4 BK4 5
1
BK1 BK1 BK1 BK2
Trigger input
wait state
Jump to line No. 2
on an event input.
This Run Mode function sets the update method for rewriting data to the output
when pattern data, the sequence, or other items are changed. Select Auto or
Manual.
Auto. Rewrites the output data with new data immediately at the point when any
change occurs to the pattern data. The START/STOP button LED indicator
blinks rapidly during data update.
Manual. The output data is not immediately rewritten when the pattern data is
changed. When the displayed data and the output data differ, the START/STOP
buttons LED indicator blinks slowly. To rewrite the pattern data, stop data output
temporarily by pressing the START/STOP button, and then restart output by
pressing the START/STOP button once again. Also note that changed pattern
data is also written when the run mode changes.
Operation.
Do the following to set the data update method.
Bottom button
Run Mode
Trigger Input
Event Jump
(Trig Wait)
On
On
2 3
BK2 BK3 BK3 BK4
Jump to line No. 0
on an event input.
Pop up menu
2
0
1
4
0
BK4 BK0 BK1
Side button
Update (Select Auto
or Manual)
DG2040 Data Generator