To Replace The Fpd + Ignitor - Agilent Technologies Agilent 7890 Series Maintenance Manual

15
Maintaining the FPD
To Replace the FPD
WA R N I N G
302
+
+
Ignitor
1 Gather the following:
• Ignitor replacement kit. (See
for the FPD
• Torx screwdrivers, T- 20 and T- 10
• 5/16- inch nut driver (or wrench)
Load the
2
become ready.
Be careful! The detector may be hot enough to cause burns. If the
detector is hot, wear heat-resistant gloves to protect your hands.
Remove the FPD cover. (See
3
on page 300.)
4 Loosen the collet screw holding the cable assembly to the
ignitor. Remove the collet and cable assembly.
Use a nut driver to loosen and remove the glow plug.
5
• If using a 5/16- inch wrench, you may need to remove
the exit tube assembly using a T- 10 Torx driver
+
" on page 290.)
GC maintenance method
"To Remove the FPD
"Consumables and Parts
and wait for the GC to
+
Cover"
Maintaining Your GC