Table of Contents
Advertisement
2.
INSTALLATION
2.1.
REAR PANEL
The following sections describe the purpose of the rear panel connectors of the 8010-SIE. Sections
2.1.1 to 2.1.7 describe the specific signals that should be connected to the 8010-SIE.
2.1.1. Digital Video Connections
SDI IN:
A BNC connector for input of 10 bit serial digital video signals compatible with the SMPTE
259M standard.
SDI BYPASS: A BNC connectors for output of 10 bit serial digital video signals compatible with the
SMPTE 259M standard. This output will normally be the video input with VITC (encoded with
source ID information) and characters inserted onto it. When the SDI bypass relay is
activated (on power failure or from the front panel) the SDI BYPASS output is a direct relay
connection to the SDI IN.
SDI OUT: A BNC connectors for output of 10 bit serial digital video signals compatible with the SMPTE
259M standard. This output will normally be the video input with VITC (encoded with source
ID information) and characters inserted onto it. When the SDI bypass relay is activated (on
power failure or from the front panel) the SDI OUT output will not have any video signal on
it.
2.1.2. Analog Monitor Video Connections (optional)
MONITOR OUT:
This output will normally be an analog video copy of the video on the SDI OUT connector.
When the SDI bypass relay is activated (on power failure or from the front panel) the
MONITOR OUT outputs will not have any video signal on them.
2.1.3. Linear Time Code Connections
LTC OUT:
A male XLR connector for output of SMPTE/ EBU linear timecode from the generator.
(Balanced)
LTC IN:
A female XLR connector for input of SMPTE/ EBU linear timecode for the reader
(Balanced)
INSTALLATION
Model 8010-SIE Digital Source ID Encoder Manual
Figure 2-1: 8010-SIE Rear Panel
Two BNC connectors for output of the optional composite analog encoder.
Revision 2.2
Page 2-1
Advertisement
Table of Contents
