Viewing Vrrp Summary; Vrrp Configuration Examples; One Subnet Network Example - ZyXEL Communications GS3700 Series User Manual

39.3.4 Viewing VRRP Summary

View the VRRP configuration summary at the bottom of the screen.
Figure 223 IP Application > VRRP Configuration: Summary
The following table describes the labels in this screen.
Table 178 IP Application > VRRP Configuration: Summary
LABEL
Index
Active
Name
Network
VRID
Primary VIP
Uplink Gateway
Priority
Delete
Cancel

39.4 VRRP Configuration Examples

The following sections show two VRRP configuration examples on the Switch.

39.4.1 One Subnet Network Example

The figure below shows a simple VRRP network with only one virtual router VR1 (VRID =1) and two
switches. The network is connected to the WAN via an uplink gateway G (172.16.1.100). The host
computer X is set to use VR1 as the default gateway.
Chapter 39 VRRP
DESCRIPTION
This field displays the index number of an entry. Click an index number to change the
settings.
This field shows whether a VRRP entry is enabled (Yes) or disabled (No).
This field displays a descriptive name of an entry.
This field displays the IP address and subnet mask of an interface.
This field displays the ID number of a virtual router.
This field displays the IP address of the primary virtual router.
This field displays the IP address of the uplink gateway.
This field displays the priority level (1 to 255) of the entry.
Click Delete to remove the selected entry from the summary table.
Click Cancel to clear the Delete check boxes.
GS3700/XGS3700 Series User's Guide
332