Static Route; Chapter 33 Static Route; Static Routing Overview; What You Can Do - ZyXEL Communications XGS1930-28 User Manual

33.1 Static Routing Overview

This chapter shows you how to configure static routes.
The Switch uses IP for communication with management computers, for example using HTTP, Telnet, SSH,
or SNMP. Use IP static routes to have the Switch respond to remote management stations that are not
reachable through the default gateway. The Switch can also use static routes to send data to a server
or device that is not reachable through the default gateway, for example when sending SNMP traps or
using ping to test IP connectivity.
This figure shows a Telnet session coming in from network N1. The Switch sends reply traffic to default
gateway R1 which routes it back to the manager's computer. The Switch needs a static route to tell it to
use router R2 to send traffic to an SNMP trap server on network N2.
Figure 190 Static Routing Overview

33.1.1 What You Can Do

• Use the Static Routing screen
screen.
• Use the IPv4 Static Route screen
route.
• Use the IPv6 Static Route screen
route.
C
N1
N2
(Section 33.2 on page 268) to display the link to the IPv4 Static Route
(Section 33.3 on page
(Section 33.4 on page
XGS1930 Series User's Guide
267
H A P T E R

Static Route

268) to configure and enable an IPv4 static
269) to configure and enable an IPv6 static
33