63.1 Static Routing Overview
This chapter shows you how to configure static routes.
The Switch usually uses the default gateway to route outbound traffic from computers on the LAN to the
Internet. To have the Switch send data to devices not reachable through the default gateway, use
static routes.
For example, the next figure shows a computer (A) connected to the Switch. The Switch routes most
traffic from A to the Internet through the Switch's default gateway (R1). You create one static route to
connect to services offered by your ISP behind router R2. You create another static route to
communicate with a separate network behind a router R3 connected to the Switch.
Figure 318 Example of Static Routing Topology
63.1.1 What You Can Do
• Use the IPv4 Static Route screen
route.
• Use the IPv6 Static Route screen
route.
Chapter 63 Static Route
C
N1
(Section 63.2 on page
(Section 63.3 on page
XMG1930 Series User's Guide
441
H A P T E R
Static Route
442) to configure and enable an IPv4 static
443) to configure and enable an IPv6 static
63