Mvr Group Configuration; Table 55 Mvr - ZyXEL Communications GS-3012F User Manual

The following table describes the related labels in this screen.

Table 55 MVR

LABEL
Active
Name
Multicast VLAN
ID
802.1p Priority
Mode
Port
Source Port
Receiver Port
None
Tagging
Add
Cancel
VLAN
Active
Name
Mode
Source Port
Receiver Port
Delete
Cancel

21.7 MVR Group Configuration

All source ports and receiver ports belonging to a multicast group can receive multicast data
sent to this multicast group.
Configure MVR IP multicast group address(es) in the Group Configuration screen. Click
Group Configuration in the MVR screen.
Chapter 21 Multicast
DESCRIPTION
Select this check box to enable MVR to allow one single multicast VLAN to be
shared among different subscriber VLANs on the network.
Enter a descriptive name (up to 32 printable ASCII characters) for identification
purposes.
Enter the VLAN ID (1 to 4094) of the multicast VLAN.
Select a priority level (0-7) with which the switch replaces the priority in outgoing
IGMP control packets (belonging to this multicast VLAN).
Specify the MVR mode on the switch. Choices are Dynamic and Compatible.
Select Dynamic to send IGMP reports to all MVR source ports in the multicast
VLAN.
Select Compatible to set the switch not to send IGMP reports.
This field displays the port number on the switch.
This field is applicable for Ethernet ports.
Select this option to set this port as the MVR source port that sends and receives
multicast traffic. All source ports must belong to a single multicast VLAN.
Select this option to set this port as a receiver port that only receives multicast
traffic. A receiver port cannot belong to a multicast VLAN.
Select this option to set the port not to participate in MVR. No MVR multicast traffic
is sent or received on this port.
Select this checkbox if you want the port to tag the VLAN ID in all outgoing frames
transmitted.
Click Add to save the settings.
Click Cancel to discard all changes.
This field displays the multicast VLAN ID.
This field displays whether the multicast group is enabled or not.
This field displays the descriptive name for this setting.
This field displays the MVR mode.
This field displays the source port number(s).
This field displays the receiver port number(s).
To delete a multicast VLAN(s), select the rule(s) that you want to remove in the
Delete column, then click the Delete button.
Click Cancel to clear the Delete check boxes.
GS-3012/GS-3012F User's Guide
138