Mld Snooping-Proxy Filtering Profile - ZyXEL Communications XGS2210-28 User Manual

Table 97 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering
LABEL
Apply
Cancel

24.4.5 MLD Snooping-proxy Filtering Profile

Use this screen to create an MLD filtering profile and set the range of the multicast address(es). Click the
Filtering Profile link in the Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy >
Filtering screen to display the screen as shown.
Figure 182 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering >
Filtering Profile
The following table describes the fields in the above screen.
Table 98 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering Profile
LABEL
Profile Name
Start Address
End Address
Add
Clear
Profile Name
Chapter 24 Multicast
DESCRIPTION
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to reset the fields to your previous configuration.
DESCRIPTION
Enter a descriptive name for the profile for identification purposes.
To configure additional rule(s) for a profile that you have already added, enter the profile
name and specify a different IP multicast address range.
Type the starting multicast IPv6 address for a range of multicast IPv6 addresses that you want
to belong to the MLD filtering profile.
Type the ending multicast IPv6 address for a range of IPv6 addresses that you want to
belong to the MLD filtering profile.
If you want to add a single multicast IPv6 address, enter it in both the Start Address and End
Address fields.
Click this to create a new entry.
This saves your changes to the Switch's run-time memory. The Switch loses these changes if it
is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Click Clear to reset the fields to the factory defaults.
This field displays the descriptive name of the profile.
XGS2210 Series User's Guide
241