Installation - Mercury 200 OptiMax Jet Drive Service Manual

Oil Injection

Installation

1. Install the rubber grommets and bushings onto the oil reservoir.
a
h
g
f
2. Install the oil reservoir onto the cylinder block and secure with two 0.312‑18 x 1.250 inch screws and washers. Tighten the
screws to the specified torque.
Description
Screws (0.312‑18 x 1.250 in.) (2)
3. Install the oil hose and secure the oil hose with a cable tie.
4. Connect the oil tank low oil switch bullet connectors to the engine harness.
Page 3C-10
b
c
d
39153
e
a - Grommet (3)
b - Bushing (3)
c - Vent cap
d - Oil reservoir
e - Reservoir oil outlet fitting to oil pump
f - Oil reservoir low oil vent
g - Low oil switch bullet connectors
h - Oil reservoir oil inlet fitting
Nm lb‑in.
19.2 170
90-8M0050731 MAY 2011
lb‑ft