Mercury 200 OptiMax Jet Drive Service Manual page 205

Direct Fuel Injection
6. Remove the metal hose clamp securing the pulse pump fuel hose to the fitting.
a
7. Remove the seven screws securing the VST cover to the VST tank. Remove the cover.
a
a
8. Loosen the screw securing the float pin. Remove the float, float pin, and needle.
NOTE: It is not necessary to remove the screw when removing the float, float pin, and needle.
9. Carefully remove the fuel pump from the VST cover. Disconnect the fuel pump electrical harness.
a
Page 3B-42
a
a
a
a
a
b
a -
b -
b
32668
a - Screw (7)
a
16050
b
c
32685
a -
b -
32686
Cable tie
Metal hose clamp
a - Float
b - Float pin
c - Screw
Fuel pump electrical harness connector
Fuel pump
90-8M0050731 MAY 2011