Mercury 200 OptiMax Jet Drive Service Manual page 204

2. Remove the two metal hose clamps securing the low‑pressure electric fuel pump outlet hose to the fittings. Remove the hose
from the fittings.
3. Remove the four screws securing the low‑pressure electric fuel pump and lift pump brackets to the VST. Remove the brackets.
4. Remove the water separator fuel filter.
5. Cut the cable tie securing the vent hose to the fitting.
90-8M0050731 MAY 2011
c
b
a
e
a - Water separator fuel filter
a
32666
a - Lift pump to water separating filter fuel hose
a
b - Cable tie
c - Low‑pressure electric fuel pump outlet hose
b
45836
c
d
45835
Direct Fuel Injection
a - Ground cable
b - Low‑pressure electric fuel pump
bracket
c - Lift pump bracket
d - Screw (M6 x 35) (1)
e - Screw (M6 x 16) (3)
Page 3B-41