Mercury 200 OptiMax Jet Drive Service Manual page 209

Direct Fuel Injection
12. Lubricate the water separator fuel filter seal with Special Lubricant 101. Install the water separator fuel filter. Tighten the water
separator fuel filter securely.
Tube Ref No.
Special Lubricant 101
34
13. Install the grommet onto the fuel filter bracket.
14. Install the low‑pressure electric fuel pump onto the fuel pump bracket. Secure the pump with two cable ties.
IMPORTANT: If the low‑pressure electric fuel pump does not have a sleeve or grommet, refer to Service Bulletin 98‑8.
a
b
15. Install the VST ground wire onto the screw, as shown.
16. Install the low‑pressure electric fuel pump bracket and lift pump bracket onto the VST. Secure the brackets with four screws.
Tighten the screws to the specified torque.
Description
Screw (M6 x 16) (3), (M6 x35)
Page 3B-46
a - Water separator fuel filter
a
32666
Description
c
35779
b
a
e
Where Used
Water separator fuel filter seal
a - low‑pressure electric fuel pump bracket
b - Cable ties
c - Grommet
c
d
45835
Part No.
92-802865Q02
a - Ground cable
b - Low‑pressure electric fuel pump
bracket
c - Lift pump bracket
d - Screw (M6 x 35) (1)
e - Screw (M6 x 16) (3)
Nm lb‑in.
11.5 102
90-8M0050731 MAY 2011
lb‑ft