Mercury 200 OptiMax Jet Drive Service Manual page 144

3. Insert the solenoid actuating plunger end into the fork of the solenoid arm.
b
a
Tube Ref No.
2-4-C with Teflon
95
4. Align the solenoid so the two solder joints are closest to starter assembly.
b
5. Install the starter brush lead onto the solenoid terminal and secure with a lockwasher and nut. Tighten the nut to the specified
torque.
6. Apply Liquid Neoprene to the starter brush lead connection to prevent corrosion.
a
Description
Nut
Tube Ref No.
Liquid Neoprene
25
90-8M0050731 MAY 2011
a - Fork of the solenoid arm
b - Solenoid actuating plunger
23485
Description
a
a - Starter brush lead
b - Nut and lockwasher
b
32114
Description
Where Used
Solenoid actuating plunger
a - Solder joints
b - Starter brush lead
32118
Where Used
Starter brush lead connection
Charging and Starting System
Part No.
92-802859A 1
Nm lb‑in.
9 80
Part No.
92- 25711 3
Page 2B-33
lb‑ft