7.
Connect the oil pump connector.
8.
Connect the harness ground lead below the starter motor.
9.
Connect the red and yellow/red leads to the starter solenoid.
10. Connect the MAP sensor connector.
11. Connect the air temperature sensor connector.
d
12. Connect the crankshaft position sensor connector.
13. Connect the water pressure sensor harness and sensor retainer.
14. Install two nuts securing the aft portion of the electrical plate.
90-8M0050731 MAY 2011
a
c
b
c
a -
Nut and washer
b -
Screw
c -
Oil pump connector
45918
a
a -
MAP sensor connector
b -
Air temperature sensor connector
c -
Yellow/red wire
d -
Harness ground lead
b
45545
Powerhead
Page 4A-69